ATE10K30M-1 - 10 kHz To 30 MHz, 3000 Watt Input Power E-Field Generator
The Model ATE10K30M-1 is a broadband, high power E-Field Generator. It uses low-inductance internal load resistors to terminate the RF power and incorporates a broadband transformer to increase the output voltage.
Click Here To Download:
• Datasheet: ATE10K30M-1 - 10 kHz To 30 MHz, 3000 Watt Input Power E-Field Generator
The Model ATE10K30M-1 is a broadband, high power E-Field Generator. It uses low-inductance internal load resistors to terminate the RF power and incorporates a broadband transformer to increase the output voltage. The transformer output is unbalanced so that the bottom flange may be unbolted from its wheeled cart and grounded, enabling use above a ground plate or turntable. These features provide a well matched input VSWR with relative freedom from reflections caused by the test object. A high power input rating enables generation of over 200 volt/meter fields. Field strength data as shown in the following specifications is derived from measurements taken at the center between the elements of the E-Field Generator using broadband isotropic field sensors and an AR RF/Microwave Instrumentation Model 2500L power amplifier. These measurements include 25-foot cable losses as well as RF field losses due to radiation and VSWR effects. The measurements were made in open air and it should be noted that, when using the Model ATE10K30M-1 in a shielded enclosure, additional field strength may be lost due to proximity of the ceiling. AR recommends the use of shielded enclosures having a minimum ceiling height of 6 meters to reduce the effect. Introducing a conductive test object into the E-Field Generator also affects field measurements, usually increasing them.
Click Here To Download:
• Datasheet: ATE10K30M-1 - 10 kHz To 30 MHz, 3000 Watt Input Power E-Field Generator